AVR-CAN - OLIMEX LTD - OLinuXino Arduino Maple Pinguino
AVR-CAN is inexpensive way to learn AT90CAN128 microcontroller from Atmel. It's in very compact form 60x55mm and the presence of both CAN and RS232 allow the customer to make bridge between UART and CAN networks. Arduino Uno R3 24,00 EUR. Angebote. Grukarten-Set - Bare Conductive. Nur 11,90 EUR Statt 22,61 EUR. PICAXE Create Starter Pack
AT90CAN128 Entwicklungskit - watterottcom
To use an Arduino as a serial cable, simply remove the ATmega328P MCU, and then connect the the TxD, RxD, and GND pins between the Arduino and the external device. The AT90CAN128 has two USART’s. The first one, on pins RXD0(2) and TXD0(3), is accessed via the Serial object in Arduino.
duino - olimex - Page 3
1/6/2018sungen gefunden, in denen ich etwas einkopieren soll damit es funktioniert.
Arduino AT90CAN128 Project - Page 4 - My Nissan Leaf Forum
Led Blinking. This is a very simple exercise whose purpose is to get you acquitted with the process of compiling, loading and checking an embedded systems program. If you're using the Atmel STK500 with an AVR AT90can128 for this exercise, I suggest you to take a look at this manual for I/O port B. If you're using an Arduino Uno with an AVR
AT90CAN128 - 8-bit AVR Microcontrollers
Chcete se naučit programovat mikrokontrols.
List of Arduino boards and compatible systems - Wikipedia
. 1 Comparison Between AT90CAN32, AT90CAN64 and AT90CAN128 AT90CAN32, AT90CAN64 and AT90CAN128 are hardware and software compatible. They dif-fer only in memory sizes as shown in Table 1-1. 1. 2 Part Description The AT90CAN32/64/128 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture.
Arduino Playground - SimilarBoards
Note for Advanced Users: The CAN485's AT90CAN128 uses an Arduino bootloader. For those that are trying to flash the chip with an AVR programmer and Atmel Studio, the ICSP pins are not in a location that you would expect.
Lincomatic's DIY Blog - electronics, 3d printing, hacking, etc
/8/2014Has anyone tested CAN communication between the AT90CAN128 and an arduino using mcp2515? I don't have the hardware yet, so I can't test, but I don't see any reason why it wouldn't work.